Back to top
Loading…
emuca - vida en los muebles

Zamierzasz usunąć ten koszyk. Jesteś pewny?

Dostęp do obszaru prywatnego Emuca - Vida en los muebles

Forum techniczne

Przedstaw nam swoje wątpliwości dotyczące naszych produktów a nasz Dział Pomocy Technicznej (SAT) skontaktuje się z tobą, aby przedstawić rozwiązanie.

Drawers and slides

The RAL code of the anthracite grey finish of the sides of the Slim kitchen, household and bathroom drawer is approximately 7043.

The RAL code of the white finish of the sides of the Slim kitchen, household and bathroom drawer is approximately 9003. Although it is necessary to bear in mind that the white silk colour of said drawer is metallized and the RAL codes are for flat colours.

In order to assemble a Slim type kitchen drawer with hinges on the unit doors (hinged doors) it is necessary to use hinges with an opening angle of 165ª or to use spacers, doing so means there will be enough space to pull out the drawer.

Yes, the spacers that are user for assembling kitchen drawers are the same as hinges on unit doors (hinged doors).

The square rail section of the Slim drawer measures 23 mm by 13 mm and the section with trim measures 25 mm by 15 mm.

The minimum unit depth required to install a Slim exterior drawer with push is calculated with the formula: Minimum depth = Depth + 3 mm.
In this case the minimum unit depth needed will be 500 + 3 = 503 mm.

The minimum unit depth required to install a Slim interior drawer with push is calculated with the formula: Min. depth = Depth + 12 mm.
In this case the minimum unit depth needed will be 500 + 12 = 512 mm.

Yes, the Lokbox mechanism is used to fasten the bottom of the drawer to the front part without preventing adjustment of it. It is compatible with the Concept, Slim and Vantage-Q drawers or any drawer. It is especially recommended for very wide drawers used in the furnishings of kitchens, bathrooms, lounges and even inside wardrobes. However, you need to take into account that the installation dimensions change. See diagram.

Is there a mechanism in order to fasten the bottom of the drawer to the front part without preventing adjustment?

Yes, for the assembly of the rectangular under sink insert it is necessary to make a 90º angle straight machining cut, although it is recommended to make a machining cut with a radius of 20 mm.

Technical questions box

You can not find the information you need? Raises your technical questions about our products and our technical department will solve.