Back to top
Loading…
emuca - vida en los muebles

Zamierzasz usunąć ten koszyk. Jesteś pewny?

Dostęp do obszaru prywatnego Emuca - Vida en los muebles

Forum techniczne

Przedstaw nam swoje wątpliwości dotyczące naszych produktów a nasz Dział Pomocy Technicznej (SAT) skontaktuje się z tobą, aby przedstawić rozwiązanie.

Drawers and slides

The following video shows how you can easily assemble the Concept drawer with back panel.

The following video shows how you can easily assemble the Concept drawer.

It is only necessary to connect the machine to air with a pressure of 7-8 kg/cm2.

The RAL code of the anthracite grey finish of the sides of the Concept kitchen, household and bathroom drawer is approximately 7043.

The RAL code of the white finish of the sides of the Concept kitchen, household and bathroom drawer is approximately 9003. Although it is necessary to bear in mind that the white silk colour of said drawer is metallized and the RAL codes are for flat colours.

The board cutting dimension and the position of the hook on the front are different. However, the hole pattern of the guide rail is the same for the Concept, Vantage-Q and Slim drawers.

Due to the fact there is separate assembly on the drawer, you can mount the Concept rails on other models of drawers. However, it is not advisable, as each drawer has its own rails and its own machining distances.

In order to assemble the aluminium back on the Concept drawer it is necessary beforehand to mount the accessories corresponding to each side height onto the profile. Subsequently, we will fasten the profile to the sides of the drawer.

In order to assemble a Concept type kitchen drawer with hinges on the unit doors (hinged doors) it is necessary to use hinges with an opening angle of 165ª or to use spacers, doing so means there will be enough space to pull out the drawer.

Yes, the spacers that are user for assembling kitchen drawers are the same as hinges on unit doors (hinged doors).

Yes, the Lokbox mechanism is used to fasten the bottom of the drawer to the front part without preventing adjustment of it. It is compatible with the Concept, Slim and Vantage-Q drawers or any drawer. It is especially recommended for very wide drawers used in the furnishings of kitchens, bathrooms, lounges and even inside wardrobes. However, you need to take into account that the installation dimensions change. See diagram.

Is there a mechanism in order to fasten the bottom of the drawer to the front part without preventing adjustment?

Yes, for the assembly of the rectangular under sink insert it is necessary to make a 90º angle straight machining cut, although it is recommended to make a machining cut with a radius of 20 mm.

Technical questions box

You can not find the information you need? Raises your technical questions about our products and our technical department will solve.