Zamierzasz usunąć ten koszyk. Jesteś pewny?
Przedstaw nam swoje wątpliwości dotyczące naszych produktów a nasz Dział Pomocy Technicznej (SAT) skontaktuje się z tobą, aby przedstawić rozwiązanie.
The following video shows how the Even truss is assembled.
The following video shows how you can easily assemble the Sling wardrobe lifts.
The gap that there is between the side of the unit and the frame /guide rails of the accessories for inside wardrobes or Moka dresser is 9 mm.
Yes, you simply need to respect the minimum installation depth of the Moka runners and carry out the assembly with the clips that are supplied.
The side supplement of the Hang fold-down hanger is used to increase the distance between the hanger and the side of the unit, avoiding the arms of the hinges. Thanks to this supplement, you will be able to mount the Hang hanger fully integrated into your wardrobe with hinged doors.
The following video shows how you can easily assemble the lateral pull-out tie rack Moka.
The following video shows how you can easily assemble the pull-out hanging rail Moka.
The following video shows how you can easily assemble the pull-out mirror Moka.
The Moka mirror is assembled on the side of a unit and needs a minimum width of 225 mm in order for the mirror to be extractable and rotating.
The following video shows how you can easily assemble the extractable trouser holder Moka.
Yes, the Moka trouser holder is available in two models, for assembly on either the right hand side or left hand side of the wardrobe, and to that end there are different codes. This completes the range of furnishing and storage options for your wardrobe or dressing room.
The following video shows how you can easily assemble the extractable shoe rack Moka.
The RAL of the finish of the accessories for inside Moka wardrobes and dressing rooms is approximately 8019.
Yes, it is only necessary to cut the cross profiles of the Keeper frame with a straight cut. In this manner you can attain an inside width of the unit less than 555 mm.
Afterwards, it will be necessary to bear in mind the new measurement of the frame in order to add the different accessories such as baskets, drawers and trouser racks.
Yes, the Self trouser holder stands out for its ease of installation and because it can change sides easily. In order to change the position of the trouser holder it is only necessary to unscrew the central body and separate it from the runners in order to change side, and unscrew the cylindrical handle and put it on the other side.
This trouser rail incorporates 37 mm full-extension ball bearing runners with a gentle sliding movement and a handle for pulling out of the furniture. Also, it has eleven chrome steel bars with non-slip rubbers for hanging trousers on.
The shelf support for a gap slot of 32 mm has two through holes, which enable access through a screw and a manual tool. This makes it possible to fasten the board if that is required, especially in assemblies with very wide continuous shelves.
You can not find the information you need? Raises your technical questions about our products and our technical department will solve.